As a regular 0201 but with fully extended flaps to give
extra protection top and bottom.

Uses
more material than a 0201 and again requires taping top and bottom.

Measurements Explained**Unless otherwise specified all dimensions
are expressed as internal dimensions in
mm as follows:**

Length (L) = the longer dimension at the opening

Breadth (B) = the shorter dimension at the opening

Height (H) = the dimension from the top of the opening to the base

The dimensions L, B, H are specified in each description of the case construction, for some models the numerical value of B can exceed the numerical value of L.

Dimensions should be measured under standard climatic conditions, on the flat blank from the centre of crease bearing the thickness of the material in mind.

**For telescope-type boxes:**

The height (h)
of the upper part (lid) should be given
as a fourth measurement after an
oblique stroke.**Example:** 355 x 205 x 120/40 mm

(L) x (B) x (H)/(h)mm**For cases with overlapping outer flaps:**

The length of the area of overlapping (o)
should be given as a fourth measurement
after an oblique stroke.**Example:** 355 x 205 x 120/40 mm

(L) x (B) x (H)/(o)mm**Each design style includes one of the
following indications:**

M = usually manual erection
A = usually automated erection

M/A = can be either manual or
automated

M+A = requires a combination of both