Enquire now
Slotted-type boxes consist of one piece with a glued or stitched manufacturers joint and bottom flaps only, which meet in the middle.
They are shipped flat, ready to use and require closing using the flaps provided, usually with tape.
All dimensions are expressed as internal dimensions in mm as follows:
Length (L) x Width (W) x Height (H)
:
Longer dimension at the opening
:
Shorter dimension at the opening
:
Dimension from the top of the opening to the base
:
A variable dimension defined by the design attributes
The dimensions L, W, H and v are specified in each description of the case construction, for some designs the numerical value of W can exceed the numerical value of L.
Dimensions should be measured on the flat blank from the centre of crease bearing the thickness of the material in mind.
For telescope-type boxes:
The height (h) of the upper part (lid) should be given as a fourth measurement after an oblique stroke.
For cases with overlapping outer flaps:
For cases with overlapping outer flaps:
The length of the area of overlapping (o) should be given as a fourth measurement after an oblique stroke.
For cases with overlapping outer flaps:
=
usually manual erection
=
usually automated erection
=
can be either manual or automated
=
requires a combination of both
=
cutting forme required
Not sure which style to use?
This selection of ‘Standard Style Designs’ is a great place to start.
For something more bespoke, contact us today.
